⚜️Steps to perform an electrofusion weld

⚜️Steps to perform an electrofusion weld:
▪️Prepare the pipe (turning and cleaning): The surfaces of the pipe that are involved in welding must be machined; That is, the surface material must be removed to allow the clean, intact material to penetrate.
▪️Mark the pipe: Mark the appropriate depth for the connection dagger or the proper place to weld the saddle parts on the pipe.
▪️Alignment and restraint of pipe and fittings according to the manufacturer’s recommendations: Align and fasten the fittings on the pipe according to the manufacturer’s recommendations and place them in the restraint clamp.
▪️Electricity: Connect the electrofusion control box to the connector and power supply and connect the power.
▪️Cooling the weld and removing the clamps: After the welding of the electrofusion joints cools, remove the clamps.
▪️Welding documentation for electrofusion joints: The electrofusion control box, which applies electricity to the joint, controls and displays the main welding parameters (time, temperature and pressure). Record this information.
If you find this article useful, please story us
🌸www.waterfitt.com

irrigation#irrigate#polyethylene#pipefitting#pefittings#ppfittings#pipe#nonmiform#irritec#plasson

dripirrigation #irrigationsystems#irrigo#waterpipe#waterpipes#pipahdpe #junction#copler#pepipes #pipefitting #saddles#buttfusion #electrofusion#compressionfittings #hdpe #dripirrigationsystem#dripirrigation #irrigazione

irrigationsystem

flangeweling

polypipe #gorgficher

پاسخ دهید

آدرس ایمیل شما منتشر نخواهد شد.قسمتهای مورد نیاز علامت گذاری شده اند *