tapping saddle, in pipes is very efficient and needed, which is why there are so many companies that provide services in this field. In fact, you can find this model of special saddles all over Iran, which is much easier for the buyer.
How does a tapping saddle work?
tapping saddle for hdpe pipe is a must and should be provided to create the proper pipe. Polyethylene electrophoresis can be used in gas pipelines and water supply lines, which is usually used more in gas distribution networks due to its high reliability, and for this reason it is approved by IGS. Electrofusion fittings are made of high quality petrochemical materials without the use of fillers and are produced in a compression category 16 times. Electrophogenic connections are made of polyethylene PE 100 and according to N12201 E and EN 1555 standards. Electrophogenic connections are available in sizes 20 to 250.Electrofusion fittings are used as the best, most suitable and most reliable stable connector in polyethylene pipes.-Up to 75 mm size, can be connected to SDR 11 pipes-From size 90 and above for SDR 17 pipes
Through the electrofusion saddle, HDPE and MDPE pipes and other plastic pipes can be made using special decorations that have electric heating elements that are used to connect the welds to each other. The polyethylene pipe must first be sealed with a grater and placed inside the electrolysis saddle (use a clamp if necessary) and a voltage (usually 40 watts) is used depending on the type of connection. The coils are then made in the heat and melted inside the saddle, which are all welded together to form a very strong homogeneity, then the assembly is cooled for a certain time. This type of connection can be used in gas transmission pipelines and water supply lines, which is usually used more in gas distribution networks due to its high reliability, and for this reason, it is approved by IGS. Using this method, various polyethylene fittings such as pipe-pipe, pipe-knee, pipe-boblin, etc. can be created. This method is mostly used because there are no other restrictions on welding methods.
Manufacturing process of tapping saddle
Electrofusion fittings are produced from high quality petrochemical polyethylene materials without the use of fillers and in the compression category 16 times. This type of connection is made of PE 100 polyethylene according to EN1555-3 and INSO14427 standards.
The process of making a saddle is not very complicated and most centers are able to produce it.
But throughout Iran, people can easily prepare and use these products without any worries. On the other hand, saddle clamp installation on the pipes is not very difficult and is possible.